Diamond drill bits for drilling glass, ceramic and stone, in common diameters of 3–150 mm.
Drill bits sit outside the edging line itself: sintered diamond drill bits handle drilling in glass, ceramic and stone, and the wear-resistant working layer keeps the hole edge clean. Shanks come in three types matched to the machine: straight and taper shanks are 8 mm as standard, 10 mm on request; threaded shanks follow 1/2″ G, with threaded bits 75 mm long as standard and 80–95 mm to order. Larger diameters are made to drawing.
2 products
drilling · glass holes
Straight, taper and threaded shanks matched to your drilling machine — 3–150 mm diameters for glass, ceramic and stone, larger sizes to your drawing.
Min. order 20
drill companion · chamfer
Optional companion to the glass drill bits — chamfers the hole edge after drilling; sleeve sizes matched to the bits.
Common diameters 3–150 mm with a sintered diamond working layer. Straight and taper shanks 8 mm, 10 mm on request; threaded 1/2″ G, 75 mm standard and 80–95 mm to order. They suit glass, ceramic and stone; special diameters to drawing.
Commonly 3–150 mm. Larger diameters are made to drawing.
Straight and taper shanks are 8 mm as standard, 10 mm on request; the threaded shank is 1/2″ G. Send the machine model and spindle type and we check before quoting.
The same sintered diamond bit handles both, but speeds and feeds differ: keep the feed low on glass to avoid chipping, while ceramic can run a little faster.
Export markets
We ship worldwide, with current volume concentrated in the markets below. If you are in a region not listed, ask anyway — the answer is usually yes.
